V2000-c Rfid Access Control User Manual [top] <HIGH-QUALITY>

Have questions about a specific feature of the V2000-C? Drop them in the comments below!

You now hold the equivalent of an advanced training course for the . This user manual has walked you from the screw terminals of the relay to the logic of anti-passback and multi-card open.

To add multiple cards, read them one after another, then press # to finish. Adding Users (Personal PIN) Enter Programming Mode. Press 1 + [4-digit User ID] + # + [4-digit PIN] + # . Deleting Users V2000-c Rfid Access Control User Manual

Symptom: Keypad keeps buzzing, and the red light is flashing quickly.

Connect the wire of the V2000-C and the Negative (-) terminal of the lock to the Power Supply GND. Have questions about a specific feature of the V2000-C

For more detailed diagrams and manual downloads, you can refer to manufacturers like Scribd's repository or specific troubleshooting steps for your installation? RFID Programming Guide

: Verify if your lock is Fail-Safe (NC) or Fail-Secure (NO). Ensure the common wire runs through the COM terminal. If using a heavy-duty magnetic lock, power it using an independent access control power box rather than drawing directly from the keypad loop. Issue 3: The keypresses do not register This user manual has walked you from the

Faulty wiring to the lock, incorrect lock type setting (NC vs NO), or insufficient power supply current.

involves proper physical mounting and exact wiring connection to an external power supply unit (PSU) and electric locking hardware. Mounting Instructions

The V2000-C uses a multi-conductor pigtail cable. Connect the wires according to this functional guide: Power Positive (+12V DC) Black: Power Negative (GND)