Hanmatek Dos1102 Manual File
Go to the Channel menu and toggle Invert to OFF. If you have a specific question about: Probe Compensation steps FFT Analysis setup USB Data Export instructions Share public link
The manual provides clear instructions to get you measuring quickly. Here’s a streamlined guide based on the manufacturer’s tutorial.
supports professional scenarios cited by Hanmatek's news blog :
Choose Rising (trigger on the way up) or Falling (trigger on the way down). hanmatek dos1102 manual
If the device begins acting erratically, you can recalibrate its internal baselines: Disconnect all probes from the front BNC inputs. Press the button. Select Self-Cal or Align from the menu system.
Match this setting in the digital menu: Press the button, look at the screen menu, select Probe , and change the value to match your physical probe ( 10X ). Step 3: Probe Compensation Alignment Attach your probe to the BNC connector for CH1 .
is a budget-friendly, dual-channel digital storage oscilloscope that has gained popularity among hobbyists, students, and engineers looking for an affordable test instrument. Featuring a 100MHz bandwidth and a 1GSa/s sampling rate, it offers significant value for troubleshooting circuits. This article acts as a comprehensive Hanmatek DOS1102 manual Go to product viewer dialog for this item. Go to the Channel menu and toggle Invert to OFF
What you are seeing on the screen (e.g., blank screen, blurry line, frozen wave)? Which menu setting you are currently stuck on? Share public link
Insert a FAT32-formatted USB flash drive into the front panel USB slot. Press the button.
You must calibrate your probes before taking any accurate measurements. Improperly compensated probes introduce severe amplitude distortions and rise-time errors. Step 1: Power On and Reset Select Self-Cal or Align from the menu system
Press the power switch. The device will perform a self-check.
Changes the timebase scale. Turning it clockwise zooms in on a specific portion of the time domain (fewer nanoseconds/microseconds per grid square).
This controls the time-base. The manual details:
The selected values will display at the bottom or side of the screen in real-time. Using Cursors for Manual Inspection
Sets the voltage threshold that a signal must cross to stabilize the display.
